Using similar "technology" as the Masuda WOW card effect, this version allows you to show a blank business card and have the printing appear on the card.  The printing seems to magically appear, visibly, through the mesh of the special card holder.  

In the original Masuda card effect, the card changes from one value to another.  Because the change in this effect is from BLANK to printed, it works best with a very BOLD design business card.  If the design of the business card is too subtle, the appearance as seen through the mesh will not be as impressive.  But if you have a bold design on your card, I heartily recommend this method of magically introducing your business card to prospective clients.  They will remember how it appeared and hold onto it.

 Uses standard business card size or slightly oversized up to width of a bridge-size playing card.    Also can turn a blank bridge size card to a printed one, but I think the effect is much stronger with a business card!

NOTE:   The holder is slightly wider than a standard business card, so the frame looks entirely filled when the gimmick shows blank, and then after the printing, the business card does not quite go out all the way to the edges.  (For those familiar with the WOW gimmick, that should make sense...)   So there is a small discrepancy when the card prints and it does not reach the edges of the frame.  But the audience is so focused on the appearance of the printing, that they do not notice this.  

Brand new with instructions  (The business card shown in the photos is not included -- just there to show how it looks when blank and when printed -- use your own business cards)

Back to previous page